Protection Iron-On Patch Protection Iron-On Patch
Measurements: 3 x 3 in.
INSTRUCTIONS:
-
Lay clean garment on a flat surface
-
Turn iron on. Make sure steam is off with no water in iron. Switch to cotton setting o (typically higher temp.)
-
Place patch onto garment where desired. Place a towel (or cotton) cloth over the patch area.
-
Apply pressure with iron in circular motions 1-3 min. over patch area to ensure adhesion. Allow patch to cool.
-
Flip garment inside-out, apply direct heat with iron onto the areas until adhered. Allow patch to cool again.
-
Check that patch has adhered completely. Repeat steps 4-6 as necessary + enjoy!
